V4 Förstärkningssats

Forum Övrigt SSR V4 Förstärkningssats

  • Detta ämne har 8 svar, 4 deltagare, och uppdaterades senast 2013-06-22 22:36 av .
Visar 9 inlägg - 1 till 9 (av 9 totalt)
  • Författare
    Inlägg
  • #7486
    eriks
    Deltagare

    Hello!

    I am about to install a förstärkningssats into a Saab 96 V4.

    See here: https://saabklubben.se/wp-content/uploads/old/reinforcement_v4.gif

    How do I best remove the original nuts for the upper whishbones so I can put in Parts number 2?

    Tack!

    Erik

    #55200
    vinkel4
    Deltagare

    Put the bolt back in the welded nut (just a few threds) and hit it hard with a hammer until it is removed from the chassie.

    #55202
    eriks
    Deltagare

    Hm, okay. That works? 😯

    #55203
    rally
    Deltagare

    Yes!! It´s very easy!!

    Fredrik

    #55347
    tikkis
    Deltagare

    @Rally wrote:

    Yes!! It´s very easy!!

    Fredrik

    Not for ”Made In Finland” 96´s. They are absolutely fast velded !

    #55362
    eriks
    Deltagare

    @tikkis wrote:

    @Rally wrote:

    Yes!! It´s very easy!!

    Fredrik

    Not for ”Made In Finland” 96´s. They are absolutely fast velded !

    Hm. I have a Valmet-96… 😥

    #55408
    tikkis
    Deltagare

    @ErikS wrote:

    @tikkis wrote:

    @Rally wrote:

    Yes!! It´s very easy!!

    Fredrik

    Not for ”Made In Finland” 96´s. They are absolutely fast velded !

    Hm. I have a Valmet-96… 😥

    :race I think, it could depending who has used the pointvelding- machine. Thats because all old Saab´s were more or less handmade. It can be also, that I have had those tight velded ones, who knows. Or, maybe because Fredrik is bigger and more muscles he think its easy task :h

    #56908
    eriks
    Deltagare

    Okay, so I can confirm:

    Hit it max. 3 times with the big Hammer and of they are. :race

    Only thing that is not so nice then is that you get away with a hole approx. 14mm diameter for a screw that is about 8.3mm (UNC-stuff). So I think I should put a small piece of tube (inside 8.3mm, outside 14mm) in that hole to center the screws. Didn’t expect that to be necessary.

    Best Regards,
    Erik

    #56917
    eriks
    Deltagare

    Okay, not necessary to put in a tube to center the screw. It centers automatically as the plate with the threads positions the screw correctly without any chance to do it wrong. :wrench

    MVH,
    Erik

Visar 9 inlägg - 1 till 9 (av 9 totalt)
  • Du måste vara inloggad för att svara på detta ämne.

Genom att fortsätta använda denna webbplats godkänner du användandet av kakor. mer information

Dina kakinställningar för denna webbplats är satt till "tillåt kakor" för att ge dig den bästa upplevelsen. Om du fortsätter använda webbplatsen utan att ändra dina inställningar för kakor eller om du klickar "Acceptera" nedan så samtycker du till detta.

Stäng