Vevhusventilation

Forum / Övrigt / SSR / Vevhusventilation

  • Författare
    Inlägg
    • oktober 1, 2002 kl. 20:44 #11525

      Hej!

      I have a problem with my ”korsinsug” that I have installed on my 1850cc-Dubbelblas-engine in my Rallye-V4.

      As I always have pressure on the crankcase (oil pressed up through the oilchecker) I discovered, that the connection to the ”insug” has no hole drilled! 😮

      This means: The air from the crankcase, that should flow into the insug and the combustion-chamber, can not get away. :confused:

      The question now is:

      Which size should the hole in the Insug have?
      Second thing is: If I drill a hole there all the air would go into cylinder 4 … So that one would have more air than the other ones?!

      So please: HELP!!!

        oktober 2, 2002 kl. 20:40 #80723

        Till vevhusventelationen skall det vara ett litet hål ca 1,5mm.

        Den andra ca 5-6mm, den är till för bromsservot.

        Vilken slang som går till vilken cylinder (2 e 4) spelar ingen roll.

          oktober 5, 2002 kl. 21:02 #80724

          hej fuling brukar inte ventilationen vara15mm

            oktober 5, 2002 kl. 21:34 #80725

            uffepuffe67:
            Ja slangen men inte hålet i insugningsröret.
            Om nu inte min vädredlösa engelska luarar mig totat så vad det hålen i insuget et var frågan om.

              oktober 6, 2002 kl. 02:04 #80726

              varför borra i insuget det går väl att sätta den i luftrenaren

                oktober 7, 2002 kl. 07:35 #80727

                Av någon anleding så finns det 2st uttag i korst ett till bromssevot och ett vevhusventelationenv tex. I vissa insug så är det borrat i genom på båda och i andra bara i ena. Är det bra borrat i ena så är det till förmodligen till bromsservot och då är hålet ca 5mm i botten.
                Håller med vaför inte sätta vevhusventelationen i luftburken, men det gäller att ha en slang från varje ventilkåpa.
                Av någon anleding så på std bilar så går en slang från en ventilkåpa till luftburken och från den andra ventilkåpan går till insuget efter förgasaren.

                  oktober 7, 2002 kl. 22:18 #80728

                  Hej!

                  Thank you for your answers. I have been on a short holiday-trip, so I could not answer.

                  I will try it with a little 1,5mm bore.

                  So I will report how it works.

                  Tack!

                  Best Regards.

                  Erik Streda

                    oktober 10, 2002 kl. 21:54 #80729

                    Hej!

                    I have drilled a 1,5mm hole and reinstalled the insug. And I have also found another thing:
                    The tubes on the valve-covers, that connect to the airfilter for ventilation, were full of oil-dirt… So no air could get through.
                    And that caused the pressure on the crankcase.

                    Now it looks like everything is ok.

                    Kind Regards

                    Erik Streda

                  • Du måste vara inloggad för att svara på detta ämne.